Silverline 457050 Good Silverline 457050 Hydraulic Bottle Jacks 6 Tonne Fast and easy ratchet height adjustment Heavy duty cast iron support post Steel base plate with broad feet
Package included: Scissor jack x 1 Handle x 1 Specification: Condition: Brand new Minimum height: about 105MM Maximum height: approximately 385MM Lifting: 2T(approx. 4400lb) Color: Black Material: Steel Net weight: 2.1KG Item Size: 41*8.8*9CM HEIGHT/CAPACITY CURVE This device is designed to sustain the following loads at these specified heights. DO NOT EXCEED the rated capacity for each position. Before Use 1. Check before each use for abnormal conditions such as cracked welds, leaks, damaged, loose or missing parts. 2. Inspect the jack immediately if lift is believed to have been subjected to an abnormal load or shock. 3. If the jack is found to be damaged, it should be removed from service until properly repaired. OPERATING INSTRUCTIONS 1. Insert the jack handle into the hole of the handle socket. 2. Make sure that the saddle is correctly positioned. To prevent damage to the jack, do not move the jack while the handle is intact in the socket. 3. To raise load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle clockwise. 4. To lower load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle counterclockwise slowly. CARE AND MAINTENANCE 1. When jack is not in use, lifting arm should be in full down position. 2. Always keep jack clean and keep the screw and bearings well lubricated. 3. Store the handle with care.
1.5 Tonne Trolley Jacks (GS Tuv) in Colour Box
Hydraulic Trolley Jack 1.5 Tonnes Faithfull Accessories
Bottle Jack ( 2000g )Ideal to place in the boot of a Car Small Van Caravan Etc This popular little jack is ideal to replace the back breaking wind up jacks The Jack comes complete with it own handle for pump the jack up an letting it down via the hydraulic tank release value for auto deflate Minimium Height is 148mm Maximum height 278mmLifted height is 80mm plus the 50mm on the adjustable screw head For maximum lift place jack under car an screw the adjustable head to the lifting point then jack the car up
Features and Benefits 2 Tonne jacking beam with adjustable pads and arms Specification Colour: Red In the Box 2 tonne capacity jacking beam with adjustable pads and arms from 700 to 970mm Has swivel action and supports suspension arms whilst raising the vehicle Suitable for most garage jacks with a removable saddle and 30mm hole, allowing you to spread the load whilst lifting Compatible with hilka: 82835020, 82940400 and 82820003